After my recent trip to Zedshed HQ … which gave the 1.9 a clean bill of health , I had a few bits to sort … All the wheel centres, the gill logos , the bonnet logo and the accelerator cable needed replacing … well today in the sunshine got it all done… worst bit being a contortionist to get to the cable connection in the footwell… 
but after a lot of swearing and a bout of cramp managed
to get it sorted.
used my old Bognor Season ticket to cut through the sealant ring… took about 2 mins to remove it.
New Bonnet badge … many thanks to
@AntStark for the new badge
4 wheel centres for £15 … from a local wheel refurbisher in Bognor
Side gill badges came from the 2.8 and used butyl to hold them in place
old throttle cable … no wonder it was a bit notchy. !!!!
This cable holder was damaged so I was going to use cable ties… then remembered I have a breaker about 3 ft away so replaced it from the one on the breaker… doh!!!
Roof down and took it out for a run to check all ok ….
but after a lot of swearing and a bout of cramp managedto get it sorted.
used my old Bognor Season ticket to cut through the sealant ring… took about 2 mins to remove it.
New Bonnet badge … many thanks to
@AntStark for the new badge
4 wheel centres for £15 … from a local wheel refurbisher in Bognor
Side gill badges came from the 2.8 and used butyl to hold them in place
old throttle cable … no wonder it was a bit notchy. !!!!
This cable holder was damaged so I was going to use cable ties… then remembered I have a breaker about 3 ft away so replaced it from the one on the breaker… doh!!!
Roof down and took it out for a run to check all ok ….
Attachments
Last edited:
